Electrical Safety; General Safety; Basic Tools And Materials Needed - Simer 2806E-02 Manual Del Propietário

Safety
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if
ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if
ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The label NOTICE indicates special instructions which
are important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
WARNING
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect power
before working on pump,
motor or tank.

ELECTRICAL SAFETY

Hazardous voltage. Can shock, burn, or
kill. Capacitor voltage may be hazardous. To discharge
motor capacitor, hold insulated handle screwdriver BY
THE HANDLE and short capacitor terminals together. Do
not touch metal screwdriver blade or capacitor terminals.
If in doubt, consult a qualified electrician.
For parts or assistance, call Simer Customer Service at
Wire motor for correct
voltage. See "Electrical"
section of this manual and
motor nameplate.
Ground motor before
connecting to power
supply.
Meet National Electri-
cal Code, Canadian
Electrical Code, and local
codes for all wiring.
Follow wiring instruc-
tions in this manual
when connecting motor to
power lines.

GENERAL SAFETY

Burn hazard. Do not touch an operating
motor. Modern motors can operate at high temperatures.
To avoid burns when servicing pump, allow it to cool for
20 minutes after shut-down before handling.
Do not allow pump or any system component to freeze.
To do so will void warranty.
Pump water only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted;
store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
Hazardous pressure. Risk of explosion.
Pump body may explode if used as a booster pump
unless relief valve capable of passing the full pump flow
at 75 psi is installed.
BASIC TOOLS AND
MATERIALS NEEDED
Plastic Pipe Installation
Tools
Pipe Wrenches
Screwdriver
Knife or Saw to Cut Plastic Pipe
Tire Pressure Gauge
Materials
Plastic Pipe and Fittings (as required to complete job).
Teflon Tape (DO NOT use joint compound on plastic
fittings).
Galvanized Steel Pipe Installation
Tools
Pipe Wrenches
Screwdriver
Pipe Cutting and Threading Tools
Tire Pressure Gauge
Materials
Galvanized Pipe and Fittings (as required to
complete job).
Pipe Joint Compound or Teflon Tape
1-800-468-7867 / 1-800-546-7867
2
WARNING
Hazardous pressure!
Install pressure relief
valve in discharge pipe.
Release all pressure on
system before working on
any component.