Compressed Air Supply - BGS technic 70056 Manual De Instrucciones

USE
The air sandblasting gun serves to remove old paint, rust and other impurities.
Ideal for cleaning surfaces, gaps and other locations difficult to access.
UNPACKING
When unpacking, make sure that all parts are present.
Contact your dealer if parts are missing or damaged.
Parts list
Parts Designation
1 Basic unit
2 Jet nozzle
3 Locking ring
4 Nozzle
5 O-ring
6 O-ring
7 Valve stem
8 Spring
9 O-ring
10 Union nut
11 Spring
12 Trigger
13 O-ring
14 Blasting material
container
15 Washer
16 Screw
17 Screw
18 Container cap
19 Handle piece
20 Compressed air
connection

COMPRESSED AIR SUPPLY

Clean air and correct pressure in the compressed air system is essential for the supply of this tool.
The maximum pressure for this tool is 6.2 bar and is recommended for most compressed air tools of
this class. Values such as the working pressure and other data can be obtained from the section
Technical Data. An increase of the pressure is necessary if the length of the air hose or other
circumstances lead to a reduction of the pressure. In this case, it may be necessary to increase the
pressure from 6.2 to, for example 7.2 bar, in order to guarantee a pressure of 6.2 bar on the tool.
Water in the hose and compressor leads to reduced efficiency and damage to the air tool. Drain the
compressed air system before each use. Use a pressure regulator with pressure gauge if the
pressure in the compressed air system is too high.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Pcs.
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed