Wurth Master WDM 201 Instrucciones Para El Manejo página 18

WDM 201.book Seite 18 Dienstag, 18. November 2008 11:36 11
Area Measurement
– Pres the button briefly. The area symbol
appears on the display and the laser is activated.
– Press pushbutton and take the first length
measurement (e. g. length).
– Press pushbutton and take the second length
measurement (e. g. width).
The two measured values and the resulting area are
indicated in the display.
The area measure is correct only when the
measurements have been taken at a right
angle to each other.
– Press and hold the button to indicate the cir-
cumference.
Volume Measurement
– Press the button twice. The volume symbol
appears on the display and the laser is switched on.
– Press pushbutton and take the first length
measurement (e. g. length).
– Press pushbutton and take the second length
measurement (e. g. width).
– Press pushbutton and take the third length
measurement (e. g. height).
The three measured values and the resulting volume
are indicated in the display.
The volume measure is correct only when the
measurements have been taken at a right
angle to each other.
– Press and hold the
additional information on circumference, wall
surface and ceiling surface.
Calculating a Trapezium (1)
– Press the button once. The trapezium symbol
appears on the display and the laser is activated.
– Press the button and take the first length
measurement (e. g. height 1).
– Press the button and take the second length
measurement (e. g. the width).
– Press the button and take the third length
measurement (e. g. height 2).
The result is indicated on the display.
– Press and hold the
additional information on inclination angle and
trapezium surface.
Calculating a Trapezium (2)
– Press the button twice. The trapezium symbol
appears on the display and the laser is activated.
– Press the button and take the first length
measurement.
18
– Press the
The result is indicated on the display.
– Press and hold the
– Press the
– Press pushbutton
– Press pushbutton
– Press pushbutton
The result is indicated on the display.
– Press and hold the
– While measuring, hold the device as level as pos-
– Press button
– Activate the laser with button
button to indicate the
– Press button
The measured angle and the distance appear on the
display.
– Press button
– Press button
After the measurement, the device returns to the dis-
tance mode.
– Press and hold the
button to indicate the
For uniform marking of distances, two clearances a
and b can be entered and saved. In the following
measurement, the currently measured distance is
compared with the clearance a and the difference is
shown on the display.
button and take the second length
measurement and the inclination angle. The inclina-
tion angle can be measured between +45° and -45°.
button to indicate the
additional information on inclination angle and
trapezium surface.
Calculating the Surface of a Triangle
button. The
on the display.
and take the first length
measurement.
and take the second length
measurement.
and take the third length
measurement.
button to indicate the
additional information on the solid angle and the
triangle surface.
Measuring Inclinations
sible (lateral inclination ±10°) with the display
facing upward.
briefly. The symbol
on the display. The current inclination angle is indi-
cated in "°" or "%", depending on the setting.
measuring the inclination.
and measure the angle.
Measuring a Horizontal Distance
twice. The symbol
on the display.
. The measured angle, the dis-
tance and the resulting calculated horizontal dis-
tance appear on the display.
button to indicate the
additional information on the inclination angle,
the distance or the indirect height.
Mark-out Function
D
F
symbol appears
appears
and align it for
appears