Initial Operation; Measuring Procedure; Measuring Functions - Wurth Master WDM 201 Instrucciones Para El Manejo

WDM 201.book Seite 17 Dienstag, 18. November 2008 11:36 11

Initial Operation

DANGER: Do not look into the laser beam!!
Switching the Tool On
The battery display appears. The tool is in its base
mode and ready to take the first measurement.
Press the button again to initiate a measurement.
The tool automatically switches off 6 minutes
after the last button actuation.
Deleting
Upon actuation, the shown value is deleted. Within
the "Area" and "Volume" measuring function, the
individual distances can be deleted and then meas-
ured again afterwards.
Front or rear stop/rest
After switching on, the zero point for all measure-
ments is at the rear edge of the measuring tool.
– Press button 1x briefly (short beep):
The zero point for all measurements is the
fronte dge of the tool
– Press button 2x briefly (short beep):
The zero point for all measurements is the
centre of the tripod mount.
– Press button 3x long (long beep):
The zero point is the rear edge of the tool
again.
Switching the Tool Off
– Press and hold the button to switch the tool off.

Measuring Procedure

D
DANGER: Do not point the laser beam at
other persons or animals!
Length Measurement
Switch on the laser with the
laser point onto the target and actuate a length measu-
rement by once more briefly pressing the
ton. The measured length is indicated in the display.
NOTE: Measurement errors can occur on the follo-
wing surfaces: Transparent liquids, glass, Styro-
foam, semipermeable surfaces, glossy surfaces.
Measurements on dark and matt surfaces lead to
increased measuring periods.
Tracking
Tracking is suitable for determining the diagonal within
a space (greatest determined length) or the
right-angled length onto a wall
length). It is also suitable for marking out distances
Switch on the laser with the
laser point onto the target and actuate the continuous
measurement by once more pressing the
ton for a longer period. During the measurement, the
laser point must be moved over the target.
A fast beeping tone sounds during the measuring.
End the measurement by pressing the
ton. The greatest, the shortest and the last measured
distance are indicated in the display.
Any measure of distance, area or volume can be
stored temporarily and recalled again:
Carry out a distance measurement.
Press and hold the button
that the measurement is stored.
Press the
culations.
Press button twice to recall the last 20 determined
measured values in reverse order.
Use the
Press the
value for a calculation.
To delete the measuring value memory, press but-
tons
Viewfinder
The tool is equipped with a viewfinder, which
directly indicates the measuring point in the display.
The crosshair 12 indicates the position, even when
the laser is not visible.
Press the
Press the
(1x to 4 x).
By activating a different measuring function, the vie-
wfinder is switched off.
The brightness of the camera can be adapted in
pushbutton. Align the
6 levels with the
pushbut-
– Measure a distance.
– Press button
– Measure a 2. distance.
– Press button
The two measured values and the result are indicated.
(shortest determined
pushbutton. Align the
Memory of Parameters
until a beep confirms
button to use this value for further cal-
Memory of Measured Values
and buttons for navigating.
button to use the displayed measuring
and at the same time.
button to activate the function.
button again to activate the zoom
or buttons.

Measuring Functions

Addition/Subtraction
or .
.
.
pushbut-
pushbut-
17