Oase InScenio Instrucciones Breves página 14

- EN -
Connecting an EGC-compatible device
The correct fastening of the plug connector is important for a secure connection and an interference-free EGC network.
• The EGC connection cable is available as an accessory in the lengths 2.5 m (47038), 5 m (47039) and 10 m (47040).
– The EGC connection cable and the EGC controller connection cable are connected with the EGC cable con-
nector.
How to proceed:
 F, G, H
1. Remove the EGC terminal resistor from the unit.
2. Fit the plug connector and secure with the two screws (max. 2.0 Nm).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
3. Remove the protection cap from EGC-OUT of the last unit in the EGC network, fit the terminal resistor EGC and se-
cure it with the two screws (max. 2.0 Nm).
– Ensure that on EGC-OUT of the last unit in the EGC network, the terminal resistor EGC is installed instead of an
EGC connection cable, to ensure that the EGC network is closed off properly.
– The scope of delivery of InScenio FM-Master WLAN or InScenio EGC Controller each contains a terminal resistor
EGC.
N O T E
The device will be destroyed if water penetrates the sockets.
• Close off sockets with plug connectors or protection caps and rubber seals.
N O T E
For further information on the operation and integration into the EGC system, please refer to the operating
manual of the InScenio EGC Controller under http://www.oase-livingwater.com/egc-start.
Connecting the power supply
How to proceed:
 E
1. Screw the plug of the supply line onto the transformer.
2. Establish the power connection.
Commissioning/start-up
The unit is operated via the "OASE Easy Control" app on your smartphone/tablet. Proceed as follows for starting up:
1. Install the app on your smartphone/tablet. (→ Installing the "OASE Easy Control" app )
2. Connect the EGC controller to the power supply. (→ Connecting the power supply)
3. Establish the WLAN connection.
The smartphone/tablet can be connected to the InScenio EGC Controller Home/Cloud in two ways (WLAN):
• The smartphone/tablet and InScenio EGC Controller Home/Cloud are connected via a WLAN router.(→ Establishing
a connection to the WLAN router (router/cloud mode))
• The smartphone/tablet and InScenio EGC Controller Home/Cloud are connected directly.(→ Establishing a direct
WLAN connection (access point mode))
14