Tripp-Lite B160-101-DPSI El Manual Del Propietario página 8

Point-to-Point Installation
7. Press the Up / Down buttons to set the Channel Number (0-63) on the
front of the transmitter unit to a number that will also be used on the
receiver unit.
Note: A locking mechanism prevents the Channel Number from being
unintentionally changed. When the Channel Number is locked, hold down the Up
and Down buttons until the Channel Number starts blinking. Then navigate to the
desired Channel using the Up / Down buttons. Once the desired Channel Number
has been selected, lock the Channel Number by holding down the Up and Down
buttons until the Channel Number stops blinking.
8. Using Cat5e/6 cable, connect the transmitter unit's RJ45 Output port to
the receiver unit's RJ45 Input port.
Note: The maximum allowable cable length from transmitter to receiver is 328 ft.
(100 m).
9. Connect a monitor to the receiver unit's audio/video Output port
(See Optional Accessories for available Tripp Lite audio/video cables).
10. (Optional) Connect the serial device's DB9 port to the receiver unit's
serial port. Depending on the model, the serial port will be either DB9 or
3.5 mm. Models with 3.5 mm jacks include a 3.5 mm to DB9 adapter.
Models with DB9 ports require standard RS-232 DB9 cable (sold
separately) for connecting a device.
11. (Optional) Connect the included IR-IN cable to the receiver unit's IR-IN
port. Place the sensor on the IR-IN cable in an unobstructed area within
clear view of the device being controlled.
Note: The IR-IN cable accepts a signal from a remote control and sends it to a
device being controlled on the other end of the installation.
12. Connect the external power supply to the receiver unit and plug it into a
Tripp Lite Surge Protector, Uninterruptible Power Supply (UPS) or Power
Distribution Unit (PDU).
8