Tripp-Lite B160-101-DPSI El Manual Del Propietario página 18

Point-to-Multipoint Installation –
Unmanaged Switch
Notes:
• Unmanaged switch installations are limited to two transmitter units. The number
of receiver units is limited to the number of ports remaining on the unmanaged
switch.
• Test to ensure the entire installation works properly before pulling cables through
ceilings/walls.
• To achieve maximum distance and performance, use 24 AWG solid-wire Cat5e/6
cable. Using stranded-wire cable or cable with a gauge (AWG) size higher than
recommended will result in a shorter extension distance. Higher-gauge cabling
(such as 26 AWG) has a limited transmission capability compared to lower-gauge
cabling. All Tripp Lite N202-Series Cat6 cables use 24 AWG solid-wire cabling.
Extended lengths of 23 AWG solid-wire Cat6a cable are available from Tripp Lite
as a custom order.
• B160-Series Audio/Video over IP Extenders are designed for use with a dedicated
network switch. Connecting IP Extenders to a switch used with other networking
equipment will result in degraded or non-functional product performance.
• The installation diagram on the next page shows HDMI transmitters and receivers
only, though any combination of transmitters and receivers (e.g. Component
Video, DisplayPort, HDMI, VGA) may be used.
• The installation diagram on the next page shows only required connections.
Optional connections (such as the IR-IN and IR-OUT Cables) are not shown.
18