Technical Specifications - Metabo BHA 18 Manual Original

9 Tips and Tricks
Only moderate pressure is required for hammer
drilling. Applying a high degree of pressure does
not increase performance.
When drilling deep holes, remove the drill bit peri-
odically from the hole to remove dust.
When drilling in tiles and other brittle materials:
Set the operating mode to
10 Maintenance
The vent slots of the machine should be cleaned
periodically.
11 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4.
A Chargers
B Battery packs with different capacities.
Use battery packs only with voltage suitable
for your power tool.
C Metabo carrying strap
D Tools with SDS-plus shank
E Connecting piece
F Geared chuck
G Twist drills for metal and wood
H Screwdriver bit
I Special grease (for lubricating the tool
shanks)
For complete range of accessories, see
www.metabo.com or the main catalogue.
12 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
13 Environmental Protection
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
"Drilling".
96/EC on used electronic and electric equipment
and its implementation in national legal systems,
used power tools must be collected separately
and handed in for environmentally compatible
recycling.

14 Technical Specifications

Explanatory notes on the specifications on page 2.
Changes due to technological progress reserved.
U
Ah
m
n
1
ø
max.
s
max.
W
Vibration total value (vector sum of three
directions) determined in accordance with
EN 60745:
a
h, HD
K
h,HD
The vibration emission level given in this informa-
tion sheet has been measured in accordance with
a standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the tool
is used for different applications, with different
accessories or poorly maintained, the vibration
emission may differ. This may significantly increase
the exposure level over the total working period.
An estimation of the level of exposure to vibration
should also take into account the times when the
tool is switched off or when it is running but not
actually doing the job. This may significantly reduce
the exposure level over the total working period.
Identify additional safety measures
to protect the operator from the effects of
vibration such as: service the
ENGLISH
Only for EU countries: Never dispose of
power tools in your household waste! In
accordance with European Guideline 2002/
= Voltage of battery pack
= capacity of the battery pack
= weight
= No-load speed
= maximum solid drill diameter
= maximum impact rate
= Single impact force
= Vibration emission value
(hammer drilling into concrete)
= Uncertainty (vibration)
ENG
13