Samsung RF31FMESBSL Guia De Inicio Rapido página 9

(4) "The CO gas concentration of the produced sparkling water is too high."
2
[CO concentration control 2]
2
1. If the concentration setting was
sparkling water the next time. (
Note that the changed concentrating setting is only applied to the subsequent production.
2. Set the concentration setting to a low level when producing sparkling water the next time and
try to produce sparkling water after emptying the sparkling water tank.
- To empty the sparkling water tank, select the "Sparkling Off" option and dispense all the
remaining sparkling water. After emptying the sparkling water, press and hold the "Sparkling
Water" button for 3 seconds to reset the cylinder and activate the sparkling water maker.
✽ Did you reset the cylinder by pressing the "Sparkling Water" button and holding for 3
seconds? If there was still water in the tank before sparkling water is produced, sparkling
water of a higher concentration than configured may be produced. However, once the
sparkling water tank is emptied, sparkling water at the configured concentration will be
produced.
(5) "I changed the CO
water didn't change." [CO
1. If you change the concentration level, the new level is applied to the subsequent production.
That is, the change does not affect the sparkling water in the sparkling water tank nor does
it affect the sparkling water production currently in progress.The change is only applied to
subsequent productions.
2. To produce sparkling water at the precise configured concentration level, empty the sparkling
water tank, set the concentration to the desired level and then produce sparkling water.
- To empty the sparkling water tank, select the "Sparkling Off" option and dispense all the
remaining sparkling water. After emptying the sparkling water tank, press and hold the
"Sparkling Water" button again for 3 seconds to reset the cylinder and start the sparkling
water maker.
✽ If there was still water in the tank before sparkling water is produced, sparkling water of a
higher concentration than configured may be produced. You have to empty the sparkling
water tank completely to produce sparkling water at the configured CO
(6) "I replaced the depleted CO
being produced.:" [ Replacing the cylinder]
1. After replacing the CO
seconds to reset the CO
Only after the CO
(7) "Sparkling water suddenly stops being dispensed even though the operation is still in
progress." [ No sparkling water ]
DA68-02942A-05.indb 9
or , change the setting to
: Low,
gas concentration level but the level of the produced sparkling
2
concentration control 3]
2
cylinder with a new CO
2
cylinder, be sure to press and hold the "Sparkling Water" button for 3
2
cylinder.
2
cylinder is reset, is sparkling water being produced.
2
English - 9
or for producing
: Medium , : High)
cylinder but no sparkling water is
2
concentration.
2
2018. 7. 31. 2:35