Faq - Sparkling Water Dispenser - Samsung RF31FMESBSL Guia De Inicio Rapido

5. FAQ – Sparkling Water Dispenser
(1) "I pressed the Ice/Sparkling lever but ice is dispensed instead of sparkling water."
[ Procedures to dispense sparkling water ]
1. Is the ice ( ,
2. If the ice icon has been selected, press the "Sparkling Water" button to select the sparkling
water option (
(2) "I pressed the Ice/Sparkling lever but no sparkling water is dispensed."
[ Producing / Off ]
1. Press the "Sparkling Water" button and then try again.
2. Check if the numbers (
that sparkling water is being produced. While sparkling water is being produced, no sparkling
water is dispensed. When the sparkling water production is complete, the numbers stop
blinking and you can dispense sparkling water.
3. If there is no blinking icon on the display panel, check if the (
sparkling water icon. This indicates that the sparkling water tank is empty but the automatic
sparkling water production function is turned off so that sparkling water is not being produced.
To produce sparkling water, press and hold the "Sparkling Water" button for 3 seconds to reset
the cylinder and start the production.
4. If sparkling water is not yet coming out, the CO
the CO cylinder.
2
After replacing the CO
reset the CO cylinder. Then, sparkling water is produced.
2
A. Check if the refrigerator door is open.
- When the refrigerator door is open, the sparkling water, water and ice dispenser functions
do not work. Therefore, close the door to use the function.
B. Check if the Child Lock function (
- When the Child Lock function is enabled, the sparkling water, water and ice dispenser
functions do not work. To disable or enable the Child Lock function, press and hold the Ice
Off button for 3 seconds.
(3) "The CO gas concentration of the produced sparkling water is too low"
2
[CO concentration control 1]
2
1. If the concentration setting was
sparkling water the next time. (
Note that the changed concentration setting is only applied to the subsequent production.
2. If the configured concentration was set to the high level (for example, the concentration level
was ) but the concentration of the produced sparkling water is low, the CO
cylinder may be empty.
In this case, replace the CO
"Sparkling Water" button for 3 seconds to reset the CO
produced.
DA68-02942A-05.indb 8
) selected on the display panel?
) and then press the "Ice/Sparkling" lever.
) next to the sparkling water icon are blinking. If they are, it means
cylinder, press and hold the "Sparkling Water" button for 3seconds to
2
) is enabled.
or , change the setting to
: Low,
cylinder. After replacing the CO
2
English - 8
) icon is displayed over the
cylinder may be empty. In this case, replace
2
or
: Medium , : High)
cylinder, press and hold the
2
cylinder.Then, sparkling water is
2
for producing
gas in the CO
2 2
2018. 7. 31. 2:35