Transport And Interim Storage; Product Data; Technical Data - Wilo Drain TS 40 Instrucciones De Instalación Y Funcionamiento

English
1. General
See start of document.
2. Safety
See start of document.

3. Transport and interim storage

Inspect the pump/system for transport damage
immediately upon arrival. Any transport damage
found must be reported to the carrier within the
prescribed periods.
CAUTION! Risk of damage to the pump!
Risk of damage due to improper handling during
transport or storage.
• The pump may only be hung from or carried
using the handle provided for transport. Never
suspend or carry using the cable!
• The pump should be protected against mois-
ture, frost and physical damage during trans-
port and interim storage.
4. Applications
DANGER! Risk of electric shock!
The pump may not be used for draining swim-
ming-pools / garden ponds or similar places
when there are people in the water.
WARNING! Risk of personal injury!
• The materials are not designed for drinking
water supply.
The pump must not be used for pumping drink-
ing water.

5.2 Technical data

Permissible components of the flow media
max. permissible grain size
Mains voltage
Mains frequency
System of protection
Speed
max. current consumption
Power input P1
Motor power rating P2
max. flow rate
max. pump lift
Operating mode S1
Operating mode S3 (optimum)
recommended operating frequency
max. operating frequency
Nominal width of pipe mount
Temperature range of the flow medium
max. immersion depth
Oil filling
22
• The pumps must not be used:
• to pump raw sewage containing faeces,
• in potentially explosive locations,
Local regulations must be observed.
The submersible motor pumps of the Wilo-Drain
TS 40 are suitable for removing dirty water and
clear fluids containing solids of max. 10 mm Ø
from shafts, pits and vessels.
They are used:
• for building and surface dewatering,
• in sewage and water-management,
• in environmental and domestic waste disposal,
• in industrial and process engineering. The pumps
• are made from stainless steel (1.4301) and plas-
tic (hydraulic).
• are normally submerged by the flow medium,
• can be installed stationary or transportable, but
only vertically.

5. Product data

5.1 Type code
Example: TS 40/10 A 1-230-50-2-10M KA,
TS
Series: submersible motor pump, waste water
40 Nominal width: 40 = Rp 1½
/10
Maximum pump lift (m): 10, 14
A
A = with float switch, connecting cable with
plug
- = not specified: without float switch,
connecting cable with free cable end for
3~motor
1-230 Mains voltage: 1~230 V, single-phase motor,
-50
Mains frequency (Hz)
-2 2 poles
-10M KA
Connecting cable length (m): 10
Mildly acidic / mildly alkaline,
Chloride content max. 150 mg/l (for 1.4301 / AISI 304),
10 mm
1 ~ 230 V, ± 10 %, 3 ~ 400 V, ± 10 %
50 Hz
IP 68
max. 2900 1/min (50 Hz)
see rating plate
see rating plate
see rating plate
see rating plate
see rating plate
200 operating hours a year
Intermittent service, 25 % (2.5 min mode, 7.5 min break)
20 1/h
50 1/h
see rating plate
+3 to 35 °C
7 m
ELFOLNA DS 22 or comparable, 410 ml
3~400 V, three-phase motor
WILO SE 03/2017