Tabla de contenido
AUTOMATIC SLICER OPERATION
Automatic slicer operation: NEVER put hand into chute arm opening on right side of
slicer. Keep hands and arms away from all moving parts.
1. Pull the food chute completely towards you and load the product onto the chute. Move the end
weight to its resting position. Note: The pin on the endweight goes into the hole on the food chute.
2. Place the product onto the food chute and then set the endweight against the product.
3. Rotate the slice thickness dial counter clockwise to the desired setting. If you happen to go past the
desired setting you must first rotate the slice thickness dial clockwise past zero "0" and then rotate
the dial back to the desired slice thickness setting. After slicing is complete, always turn the slice
thickness dial clockwise past zero "0" until it stops to close the slicer table.
4. Move the auto engage lever into the "Automatic" position.
BE ALERT. The next step will cause the food chute to move automatically and it can move
either direction on start up.
NEVER attempt to adjust, load or unload food chute when slicer is in automatic operation.
5. Press the start button. The power indicator light will illuminate.
NOTE: If the slicer does not start and there is a flashing 4, the food chute is not in the home
position. Pull the food chute completely towards you and restart the slicer.
NOTE: If the slicer does not start and there is a flashing 2, the knife cover is not on or on correctly.
Make sure the knife cover is securely in place and restart the slicer.
6. To adjust the chute speed press the slower or faster buttons. The slicer defaults to speed 5 when
the power cord is unplugged and plugged back in. If the slicer is turned off but not unplugged, it will
return to the last speed used.
7. When you are finished slicing press the stop button. The food chute will return to the home
position.
8. Turn the slice thickness dial clockwise past zero until it stops. Note: The dial will bounce back
some. Make sure the food chute is completely towards the operator.
9. Remove the product from the food chute.
For your safety, when changing product, turn the slicer off, make sure the food chute is in the
home position and close the slicer table.
OPERATING INSTRUCTIONS
Page 9
Tabla de contenido
