Change Between "Mg/M3" And "Ppm - SICK SIDOR E Instrucciones De Operación

2
ENGLISH
2.3 Change between "mg/m
12
A D D E N D U M T O O P E R A T I N G I N S T R U C T I O N S | SIDOR E
3 " and "ppm"
Note: Component oxygen (O
changed.
Fig. 3: Operating and display elements
ModularSystem
Press "ESC" as often as required until you reach the main menu.
1
Main menu
1 measuring display
2 device status
3 control
4 calibration
5 maintenance signal
Enter digit
No messages
CO 12 mg/m3
Press "." (decimal point) to extend the menu selection.
2
Main menu
1 measuring display
2 device status
3 control
4 calibration
5 maintenance signal
6 settings
7 service
Enter digit
No messages
CO 12 mg/m3
Press key "6" to go to the "settings" menu.
3
A warning is displayed: Read the warning and confirm with "Enter".
4
Press key "2" to go to the "measurement" menu.
5
Press key "3" for "meas. value display".
6
Press key "1" to go to the "meas. component" menu. Select the measuring component
7
for which the physical unit is to be changed. Confirm your selection with "ENTER" and
exit the menu with "ESC".
Press key "4" to go to the submenu where you can switch between "mg/m³" and "ppm".
8
) is always shown in the physical unit % by vol. and cannot be
2
← standard functions
←
←
←
←
← operation information
← status messages
← measured values (alternating)
← "settings"
7 8 9
Esc
Function
4 5 6
Help
Service
1 2 3
Alarm
0
Enter
8019968/V1-0/2016-06 | SICK
Subject to change without notice