Tabla de contenido
2
ENGLISH
2.1
About this document
2.2
Preparations
8019968/V1-0/2016-06 | SICK
Subject to change without notice
WARNING:
▸
This document is only valid in combination with the SIDOR Operating Instructions.
▸
You must have read and understood the SIDOR Operating Instructions (see delivered
CD-ROM).
These short instructions describe settings you can make to use the additional features of
the SIDOR E.
You can make these settings:
After the device has been integrated in the measuring system
●
or"
Before the device has been integrated in the measuring system.
●
Note: Check the setting of the power voltage is correct (see "Operating Instructions
SIDOR").
Use the supplied power cable to connect the device to a suitable power supply and
switch it on using the main power switch on the rear of the device.
You can make the following settings after booting the device:
Change the physical unit in which the measured values are shown between mg/m³ and
●
ppm.
Adapt the preset measuring range according to your application.
●
A D D E N D U M T O O P E R A T I N G I N S T R U C T I O N S | SIDOR E
2
ENGLISH
11
Tabla de contenido
