Cleaning Upholstery - Hoover Brush 'N' Wash Manual Del Usuario

Cleaning upholstery

Read "Before you begin cleaning"
Instructions on page 10.
Ensure that your upholstery can be
agent. Important: This appliance must
cleaned using a water based cleaning
not be used on materials which
require dry cleaning. If in doubt, you
should seek guidance from the uphol-
stery manufacturer.
instructed on pages 11 and 12. Agitator
Attach hose and solution tube as
brushes will not rotate while solution
tube is connected to cleaner.
Fill clean solution tank with HOOVER
Carpet/Upholstery Detergent according
Do not point tools toward people or
to instructions on pages 7 and 8.
pets.
earthed electrical socket.
Dry hands and plug cleaner into an
Turn cleaner on.
Maintenance
R R e e m m o o v v a a b b l l e e
b b r r u u s s h h e e s s
Your cleaner is equipped with remov-
able brushes for easy cleaning.
Disconnect cleaner from electrical T T o o r r e e m m o o v v e e b b r r u u s s h h e e s s
outlet.
To prevent possible leaking, remove
clean solution tank and recovery tank.
Set tanks aside.
56
B
B
B
B
56 Press all four latches (B) and pull
brush block out. The brushes can
be cleaned under running water.
14
52
Gently press the nozzle onto the
52
fabric. Press the solution trigger
and slowly pull the nozzle over the fab-
ric.
Overlap strokes by 15 mm to help pre-
vent streaking.
Make additional strokes without pressing
the trigger to remove more moisture.
To clean in corners or creases, lift the
nozzle 15 mm from the fabric and press
the solution trigger.
Vacuum up the solution with the nozzle
without pressing the trigger.
54
54
Press handle release pedal to
lower handle. Turn cleaner over so
bottom is facing up.
C
D
57
F
E
C
T T o o r r e e p p l l a a c c e e b b r r u u s s h h e e s s
Align posts (C) on both ends of
57
brush assembly with slots (D) in
cleaner housing.
Make sure that square post (E) also
aligns with square hole (F). Turn brushes
slightly until post fits easily into hole.
53
For heavily soiled areas, it may be
53
necessary to repeat the cleaning
process. Make crisscrossing strokes to
Make no more than 2 passes with the
the original pattern; overlap each pass.
solution over any one area to prevent
overwetting and damage to fabric.
If additional cleaning is necessary, wait
until the upholstery is completely dry
before using the nozzle again.
Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see "Automatic
shut-off", page 6).
When finished cleaning, follow "After
cleaning" instructions on page 10 and
"After using stair/upholstery nozzle"
instructions on page 12.
55
A
B
55
Grasp inner portion of brush (A)
and pull brush assembly out slightly
to reveal latches (B).
58
D
58 Press brush assembly firmly to snap
into place.
B
B