Merrithew SPX Reformer Manual Del Propietário página 15

3 . Insert spring bolt through the corresponding hole on spring
anchoring bar.
. Hold xed cube nut in place with 7/16" wrench.
5
Using second wrench, tighten the new nylon locknut.
CAUTION: Do not overtighten.
. Repeat steps 1 to 6 for remaining springs.
7
Required Tools
4 . Add washer and thread nylon locknut onto spring bolt.
Do not reuse old nylon locknuts or washers.
NOTE:
. Both nylon locknut and xed cube nut should be snug against
6
the spring anchoring bar. Once secure, give the nylon locknut an
additional 1/4 turn clockwise.
CAUTION: Do not overtighten.
. Af x the sticker provided with your spring replacement
8
package to the underside of the Reformer carriage.
within that period.
1x Phillips Screwdriver
2x Open-End Wrenches
1/2" x 7/16" (13 mm x 11 mm)
15