Operation With Floor Cleaner; Care Instructions; Cleaning - Steinbach Classic 250N Active Balls+ Manual Original

Operation with floor cleaner

Use a skimmer with a screen basket or similar device if your filter system
does not feature a prefilter to prevent foreign objects from damaging the
device.
Observe the instruction manual notes of the floor cleaner. Air must not
penetrate the filter system to prevent the system running dry and
overheating.
You can connect the hose of the floor cleaner directly to the suction line of the filter
system. The hose of the floor cleaner must be completely filled with water.
1. Switch the pump
power plug.
2. Press and hold down the valve lever
the valve head
3. Set the valve lever to the "FILTER" position
and release it.
In the case of very dirty water, you can
select the "WASTE" mode alternatively
(see section "Modes").
The floor cleaner is connected to the filter system.

Care instructions

The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure
hygienically clean water.
- Consult an expert and observe the dosage.

Cleaning

Improper cleaning might damage the device.
- Clean the surface of the device with plain water after each use.
- Do not use any aggressive cleaning agents.
- Do not use any sharp or metal objects such as knives, hard
scrapers or similar.
- Do not use any cleaning brushes.
- Do not use a high-pressure cleaner.
46
off by pulling the
3
.
1
13
on
23
NOTICE!