Quick Reference Guide; Site Selection And Preparation - Dimplex DCF44GS Manual Del Propietário

Quick Reference guide

1. Prior to the first use of the
fireplace verify the following:
• are the circuit breakers for
the unit on?
• are the light bulbs in your
fireplace loose? (to check,
follow the instructions for
replacing the light bulbs
under the Maintenance
section of this manual)

Site Selection and Preparation

!
NOTE 1: a 15 amp, 120
Volt circuit is required. a
dedicated circuit is preferred
but not essential in all cases. a
dedicated circuit will be required
if, after installation, the circuit
breaker trips or fuse blows on a
regular basis when the heater is
operating. additional appliances
on the same circuit may exceed
the current rating of the circuit
breaker.
WARNINg: Ensure the power
cord is not installed so that it is
pinched or against a sharp edge
and ensure that the power cord is
stored or secured to avoid tripping
or snagging to reduce the risk
of fire, electric shock or injury to
persons.
• Construction and electrical
2. The heater on your fireplace
may emit a slight, harmless
odor when first used. This
odor is a normal condition
caused by the initial heating
of internal heater parts and
will not occur again.
3. The information regarding the
model of your fireplace can
be found on the rating plate
located on the front of the
unit.
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
• Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons,
always use a licensed
electrician.
• This section provides
instructions for selecting a
location and preparing the
site to install the fireplace
into your Dimplex mantel
surround.
1. Select a suitable location that
is not susceptible to moisture
and is away from drapes,
furniture and high traffic.
7