Ratio PRO XF20-S Manual De Instrucciones página 48

H
4. CUTTING GUIDE (SEE FIG.I1, I2)
There is a cutting guide notch on the front of
the base plate for use with a parallel guide. For
straight cuts, use the 0º guide mark to align with
your parallel guide scale. For a 45º bevel cut, use
the 45º guide mark to align with your parallel guide
scale. Securely clamp the parallel guide. Always
make a trial cut to check the setting.
I1
I2
5. PARALLEL GUIDE ADJUSTMENT (SEE
FIG.J)
It is used for making cuts parallel to a workpiece
edge at a chosen distance. Slide the parallel guide
arm through the fixture to achieve the required
cutting distance then tighten the lock knob to
clamp. It can be used from both sides of the base
plate. For straight cuts, use the 0° guide mark
to align with your parallel guide scale. For a 45°
bevel cut, use the 45° guide mark to align with
your parallel guide scale. Securely clamp the
parallel guide.
Note: It is best to carry out a trial cut.
48
J
6. BEVEL CUTS (SEE FIG. K)
Set required bevel angle between 0° and 45°. Do
not use the depth of cut scale when making bevel
cuts due to possible inaccuracy.
K
7. HEX KEY STORAGE (SEE FIG. L)
The hex key provided can be placed in the area
under the machine motor.
L