Tabla de contenido
Idiomas disponibles
Idiomas disponibles
If the battery pack is very hot you must remove
your battery pack from the charger and allow
time for the battery to cool down before
recharging.
Please charge the battery to reach full before
storage. If the tool will not be used for long
periods of time, charge the battery every 3
months.
F1
green
light
F2
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
The light will be green.
2) Slide the battery pack into the charger, make
sure the battery is in the correct charge position
firmly. The light will turn to red to indicate the
charging process has started.
3) When charging is completed, the light will turn
to green.
4) After fully charged, unplug the charger and
remove the battery pack.
Note: If the battery pack is locked in the charger,
press the battery pack release button and
remove it.
WARNING: When battery charge runs
out after continuous use or exposure
to direct sunlight or heat, allow time for the
battery to cool down before re-charging to
achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original pack
is defective and should be returned to a service
center or recycling service center.
If the new battery pack displays the same
problem as the original Battery Pack, have the
charger tested at an authorized service center.
Light
Red on
Red flash
red
light
Green on
Green flash
The battery chargers and the battery packs
illustrated or described above are not included
in the delivery.
2. HAND GRIP POSITION (SEE FIG. G)
Always hold your saw firmly with both hands when
operating.
G
3. SWITCHING ON AND OFF (SEE FIG. H)
Your switch is locked off to prevent accidental
starting. Depress the lock off button, then the on/
off switch and release the lock off button. Your
switch is now on. To switch off, just release the on/
off switch.
The blade may continue to rotate after switching
off. Wait until the machine comes to a complete
stop before setting down.
ON/OFF
Status
flash
Charging
- - - -
Defective Bat-
tery
Fully Charged
- - - -
Hot/Cold Delay
47
Tabla de contenido
