Ratio PRO XF20-S Manual De Instrucciones página 45

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use:
The machine is intended for lengthways and
crossways cutting of wood with straight
cutting lines as well as bevel angles to 45°
while resting firmly on the work piece.
ASSEMBLY
1.CHANGING THE SAW BLADE
_ Before any work on the machine itself,
remove the battery.
_ Wear protective gloves when mounting the
saw blade. Danger of injury when touching the
saw blade.
_ Only use saw blades that correspond with
the characteristic data given in the operating
instructions.
_ Do not under any circumstances use
grinding discs as the cutting tool.
For changing the cutting tool, it is best to
place the machine on the face side of the
motor housing.
REMOVING
Press the spindle lock button and keep it
depressed. The spindle lock button may be
actuated only when the saw blade is at a
standstill. Loosen the blade bolt in clockwise
direction with the hex key. (See Fig. A1). Remove
the outer flange. Tilt back the lower blade guard
and hold it firmly with the lower guard lever.
Remove the saw blade. (See Fig. A2)
MOUNTING
Clean the saw blade and all the clamping parts
to be assembled. Tilt back the lower blade guard
and hold it firmly with the lower guard lever. Place
the saw blade onto the inner flange. Assemble the
outer flange and the blade bolt. Use the hex key
to tighten the blade bolt in anti-clockwise direction
firmly. (See Fig. A3)
_ Take care that the mounting positions of the
inner flange and outer flange are correct.
_ When mounting: Ensure that the cutting
direction of the teeth (direction of arrow on
saw blade) and the direction-of-rotation arrow
on the blade guard match.
A1
1
2
A2
2
A3
2. ADJUST THE CUTTING DEPTH (SEE FIG.B)
Lift the Cutting Depth Lock Knob and raise the
saw body away from the base plate. Set the depth
of cut with the scale and push the lever down to
lock. Always add 3mm to your depth of cut so that
the blade can cut through the material.
B
2
1
3. BASE PLATE ANGLE ADJUSTMENT (SEE
FIG. C1, C2)
Turn the base plate bevel lock in anti-clockwise
1
45