Tabla de contenido
Idiomas disponibles
Idiomas disponibles
direction to loosen the angle scale. Tilt the base
plate away from the machine until the required
cutting angle is adjusted on the angle scale.
Tighten the bevel lock by turning it in clockwise
direction. Do not use the depth of cut scale when
making bevel cuts due to possible inaccuracy.
C1
C2
4. DUST EXTRACTION (SEE FIG. D)
Fasten the vacuum adapter onto the dust
extraction outlet until it latches. Directly connect a
suitable vacuum hose to the adapter.
Note: The vacuum adapter must not be
mounted when no external dust extraction
is connected. Otherwise there is danger of the
extraction system becoming clogged.
Clean the vacuum adapter regularly to ensure
optimum dust extraction. The vacuum cleaner
must be suitable for the material to be worked
D
OPERATION
1. BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERY
46
NOTE:
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool down
before recharging.
When the battery pack is charged for the first
time and after prolonged storage, the battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK (SEE
FIG E1)
Depress the Battery Pack Release Button firmly
first and then slide the Battery Pack out from
your tool.
E1
C) TO INSTALL THE BATTERY PACK (SEE
FIG E2)
Slide the fully charged Battery Pack onto the tool
with sufficient force until it clicks into position.
E2
D) CHARGER (ACG18LD3/ACG1830D)
CHARGING YOUR BATTERY PACK (SEE FIG.
F1, F2)
Do not use any charger other than that
specifically provided for use with the equipment.
1
2
Tabla de contenido
