Operation - Dimplex BF45DXP Manual Del Propietário

Operation

Figure 1
Overheat
Indicator
WARNING: This electric firebox
must be properly installed before it
is used.
Manual Controls
(Figure 1)
The controls for the Electric
Fireplace are located at the bottom
right hand corner of the unit.
CAUTION: Ensure that the
Voltage Selector switch is set to
the appropriate voltage (115V
or 230V)
A. On/Off Switch
The on/off switch energizes the
firebox and flame.
B. Mode Selector Switch
Select preferred feature:
• "o" for flame only
• "-" for fan only/flame
• "=" for heat/flame
6
C. Voltage Selector
Switch
Manual Controls
! NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
of internal heater parts and will not
occur again.
C. Voltage Selector Switch
Needs to be set to reflect the
incoming voltage to the unit - 115V
or 230V.
Resetting The Temperature
Cutoff Switch
The heater on this fireplace is
protected with a safety device to
prevent overheating. Should the
heater overheat, the Overheat
indicator will be activated
(Fig. 1), and an automatic cutout
will turn the heater off and it will
not come back on without being
reset. It can be reset by switching
B. Mode
Selector Switch
A. On/Off
Switch
www.dimplex.com