Starting And Stopping; Operating The Blower - Ryobi RY08420A Manual Del Operador

WARNING:
Always shut off engine before fueling. Never remove fuel
cap or add fuel to a machine with a running or hot engine.
Make sure the unit is sitting on a flat, level surface and
only add fuel outdoors. If the engine is hot, let the unit cool
for at least five minutes before adding fuel. After fueling,
immediately replace fuel cap and tighten securely. Move
at least 30 ft. from refueling site before starting engine. Do
not smoke and stay away from open flames and sparks!
Failure to follow these instructions could result in a fire
and cause serious personal injury.

STARTING AND STOPPING

See Figures 8 - 10.
Blower should be on a flat, bare surface for starting.
 Slowly press the primer bulb 10 times.
NOTE: After the 10th press, fuel should be visible in the
primer bulb. If it is not, continue to press the primer until
you see fuel in the bulb.
 Release the cruise control, pull cruise control lever all the
way up (set to Idle).
 Set the choke lever to the START position A.
 Pull starter grip and rope sharply until engine attempts to
run. Do not pull the starter grip and rope more than five
(5) times.
 Set the choke lever to the RUN position B.
 Pull the starter grip and rope until the engine runs. Do not
pull the starter grip and rope more than six (6) times.
NOTE: If the engine does not start, return to the START
position and repeat the steps that follow.
 Allow the engine to run for 20 seconds before using the
blower.
TO STOP THE ENGINE:
 To stop the engine, depress the STOP switch to the stop
position " O ".
HOT RESTART OF THE ENGINE:
 Set the choke lever to the RUN position B.
 Push cruise control lever down and stop at the desired
throttle setting.
 Pull the starter grip and rope until the engine runs.
IF ASSISTANCE IS REQUIRED STARTING THIS PRODUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-860-4050.
OPERATION

OPERATING THE BLOWER

See Figure 11.
WARNING:
Engine housing can become hot during operation. Do not
touch or place any part of your body or clothing on the
engine housing, vents surrounding the muffler, or exhaust
port when starting, operating, or transporting the blower.
Stop and allow the engine to cool down for at least 15 min-
utes prior to storing the blower and do not allow blower to
contact combustible materials when storing. Contact with
the engine housing, muffler vents, or exhaust gases could
result in serious burns and/or ignite combustible materials.
NOTICE:
Always operate your product in compliance with all ap-
plicable laws and ordinances.
 Slip arm through harness strap and onto shoulder, then
repeat for the other shoulder. Adjust the straps to a com-
fortable position. Refer to Adjusting Harness Straps
earlier in this manual. Remove unit for starting.
 Start the blower. Refer to Starting and Stopping earlier
in this manual.
 Put on the blower again. The unit should be operated on
the operator's right side as shown.
 To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
 Operate power equipment at reasonable hours only —
not early in the morning or late at night when people
might be disturbed. Comply with the times listed in local
ordinances.
 To reduce sound levels, limit the number of pieces of
equipment used at any one time.
 Operate blower at the lowest possible throttle speed to
do the job.
 Check your equipment before operation, especially the
muffler, air intakes, and air filters.
 Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
 Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches, and
gardens.
 Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
 Use the nozzle for larger volume, so the air stream can
work close to the ground.
 After using blowers or other equipment, CLEAN UP!
Dispose of debris properly.
9 — English