Continuity Test - ring AutoTester RMM500 Instrucciones

5.7.1 Pulse Count Mode
1. Turn Selector Dial to Frequency (Hz position)
2. Select Pulse Count Mode then press
3. Connect probes to circuit to be tested red=positive(+), black=negative(-)
4. Display will show the frequency of pulses in the circuit under test.
No measurement Example frequency
5. Press exit button to return to Main Menu
5.7.2 Duty Cycle Mode
1. Turn Selector Dial to Frequency (Hz position)
2. Select Duty Cycle Mode then press
3. Connect probes to circuit to be tested red=positive(+), black=negative(-)
4. Display will show the duty cycle of pulses in the circuit under test.
No measurement Example Duty Cycle
5. Press exit button to return to Main Menu

5.8 Continuity Test

1. Turn Selector Dial to Continuity (
2. Connect probes to either end of circuit to be measured
3. Beeper will sound if continuity is detected
10422 RMM500 Instructions UK 140x170mm 15pp MULTI LANGUAGE.indb 12
button to continue
Peak to Peak Voltage
during test
button to continue
position)
12
GB
23/08/2017 17:13