Adjusting The Telescopic Handle; Switching On And Off; Operation; Working Safety - Deltafox DG-ECS 7120 T Traducción Del Manual De Instrucciones Origina

GB
2. Put on the shoulder strap (21) (see
also picture
3. Adjust the strap length such that the
carabiner hook is at hip height.
4. In addition, you can adjust the
height of the eyelet for the shoul-
der strap (12) on the telescopic
tube (10) after loosening the Phillips
screw (12a) on the eyelet.
Adjusting the telescopic
handle
The telescopic handle (10) is infinitely
adjustable using the quick release (9)
1. Flap out the quick release (9) on the
telescopic handle (10).
2. Pull or push to adjust the length of the
telescopic handle (10).
3. Reclose the quick release (9).

Switching on and off

1. Form a loop at the end of the ex-
tension cable and hang this in the
cable relief (15) at the operating han-
dle (13).
2. Connect the equipment to the mains.
3. Hold the saw firmly with both hands,
with the right hand on the operating
handle and the left hand on the round
handle. Thumbs and fingers must be
firmly around the handles
(see picture
4. To switch on, operate the start
lock (16) then press the on/off
switch (14): the equipment runs at top
speed. Release the start lock (16).
5. The electric pole-mounted pruner will
switch off when you release the on/off
button (14).
A continuous operation setting is not
possible.
94
).
).

Operation

Working safety

• Observe the specified working angle
in order to guarantee safe working.
• Work vigilantly and endanger nobody
when sawing. Work calmly and con-
siderately.
• Ensure a safe stance without being
hampered by branches, stones and
trees. Do not use the equipment when
standing on a ladder. Always keep the
cutting gear in view when working.
• On a slope, always stand above or to
the side of the branch to be sawn.
• Work only in adequate visibility and
light conditions.
• Hold the equipment as close to the
body as possible. This gives you the
best balance.
• Always hold the equipment firmly with
both hands.
• Carry the equipment by the telescopic
handle with the cutting device pointing
backward. Attach the chain guard for
transporting the equipment (see

Sawing techniques

Be strictly aware of the risk from
rebound and from branches fall-
ing or lying on the ground.
• Sawing off small branches:
Apply the impact surface of the saw
to the branch in order to avoid sud-
den movements of the saw at the start
of cutting. Guide the saw downward
through the branch with slight pres-
sure from above. Be mindful of pre-
mature breaking of the branch if you
have misjudged the size and weight.
).