Fitting The Blade And Saw Chain; Tension The Saw Chain; Assembling The Round Handle - Deltafox DG-ECS 7120 T Traducción Del Manual De Instrucciones Origina

GB
Before activating the equipment, you must:
- Assemble the blade, saw chain and
chain wheel cover and adjust the
chain,
- Assemble the round handle,
- Fill with chain oil,
- Put on the shoulder strap
Fitting the blade and
saw chain
1. Switch the saw off and unplug it from
the mains. (
A
2. Undo the blade fixing screw (5) and re-
move the chain wheel cover (6) (small
picture).
3. Spread the chain (2) out into a loop
with the cutting edges running clock-
wise .
4. Slide the saw chain (2) into the
bar guide groove. To mount the guide
bar (3), raise it to an angle of approx.
45 degrees. This will make it easier
to replace the saw chain (2) onto the
sprocket (24). It is normal that the saw
chain (2) is slack.
5. Lay the blade (3) with the central longi-
tudinal cut over the blade guide (25).
Sagging in the chain is normal.
6. Position the sprocket chain wheel cov-
ering (6). First place the tab (26) on the
cover into the corresponding notch on
the sprocket chain wheel covering (6).
Only lightly tighten the blade fixing
screw (5), as you will still have to ten-
sion the saw.

Tension the saw chain

The tension of the saw chain (2) is impor-
tant for your safety and for the function of
the equipment. A correctly tensioned saw
chain (2) increases the durability of your
equipment.
92
31).
Check the chain tension before
each use of the equipment.
• The saw chain (2) is correctly ten-
sioned if it can be pulled around the
blade (3) by hand without sagging
(wear protective gloves).
• When the saw chain (2) is pulled with
a tensile force of 10 N (approx. 1 kg),
the distance between saw chain (2)
and blade (3) should be no more than
4 mm.
1. Hold the blade (3) firmly at the tip.
To tension the saw, turn the chain ad-
justment ring (4) clockwise.
To loosen the tension, turn the chain
adjustment ring (4) anticlockwise.
2. Tighten the blade fixing screw (5)
firmly.
For new saw chains (2), the chain
tension must be readjusted again
after a short time in operation.
Assembling the round
handle
1. Undo the two screws on the round
handle (11) supplied and take off the
rivet dolly (11a).
2. Place the round handle (11) in the
desired position on the telescopic
handle (10) and fit the rivet dolly.
3. Screw together the round handle (11)
and rivet dolly (11a).
4. The height or holding angle of the
round handle can be adjusted at any
time by slightly loosening both screws,
pushing/turning and retightening the
screws.