Kohler STERLING 600C Serie Guia De Instalacion página 5

Panel
Guide
2. Install the Panel Guide
Measure and mark the exact center of the bottom track.
Center the panel guide on the center mark. Be sure the high side of the panel guide faces the
shorter leg of the bottom track.
Mark the location of the hole in the center guide. Set the panel guide aside.
Drill a hole through the bottom track using a 1/8" drill bit.
Attach the panel guide to the bottom track with one #6-32 x 5/16" flathead screw.
3. Locate the Bottom Track
NOTE: The bottom track must sit flat. If the bath/shower ledge has a curve in the corners or is
constructed of fiberglass, it may be necessary to shape the ends of the track with a file.
Place the bottom track on the flattest part of the bath/shower ledge with the leg toward the outside
of the shower.
Position the bottom track so there is an equal gap between each wall and the ends of the bottom
track.
Temporarily secure the bottom track to the ledge with masking tape.
Mark the ledge along the front edge of the bottom track with a soft pencil.
Sterling
#6-32 x 5/16"
Flathead Screw
Screw
Bottom
Track
Equal gap at
each end.
5
Bottom Track
Leg
1034040-2-B