Guide Rail - Flex CS 60 WET Manual De Instrucciones

Feed the saw evenly through the

material.
If required, re-adjust the water supply.

After cutting:

– Switch off the saw. Cutting-off wheel
continues running briefly!
– Turn off water supply.
At the end of work:

Thoroughly clean the electric power tool
and accessories.

Guide rail

A guide rail (800 mm long) for the stone
separator is available from any FLEX-
customer service centre (order no. 353.280).
To extend the guide length, 2 guide rails
can be connected to each other.
To do this, a connector is available from
any FLEX customer service centre
(order no. 353.272).
Fitting the connector:
Remove protective caps from the guide

rails.
Push connector halfway along the

guide rails.
Clamp cams (4x).

26
"Sawing in" the guide rail:
NOTE
Before using the guide rail for the first time,
cut the anti-splinter shoe to the required
width. It is recommended to use a new
diamond-tipped cutting-off wheel.
Set the mitre angle to 0°.

Set cutting depth to 15 mm (1.).

Place guide rail on a stable, level support

ensuring that the anti-splinter shoe
projects at the front.
Switch on saw.

Place saw with the inner guide groove

on the guide rail (2.).
Feed saw evenly in the direction of the

cut as far as the end of the guide rail (3.).
CS 60 WET