Switching On And Off; Setting The Cutting Depth; Setting The Mitre Angle - Flex CS 60 WET Manual De Instrucciones

Switching on and off

CAUTION!
For reasons of safety the safety switch is
not locked and must be held down during
sawing.
Switching on
Press and hold down the switch

interlock (1.).
Press and hold down the safety switch (2.).

Release switch interlock (3.).

Switching off
Release safety switch.

Switching on the power tool again
following a power failure
WARNING!
Before switching on the power tool again
following a power failure, always determine
the cause of the power failure.
Do not switch on the electric power tool
again until safe operation is possible.
Check function of the PRCD switch.
24

Setting the cutting depth

NOTE
To ensure optimum cutting results, the dia-
mond-tipped cutting-off wheel may project
a maximum 3 mm out of the workpiece.
Pull out the mains plug.

Release clamping lever for setting

the cutting depth (1.).
Set required cutting depth (2.): Lift saw

off saw bench = shallower cutting depth.
Tighten clamping lever (3.).


Setting the mitre angle

NOTE
In the case of mitre cuts, the cutting depth
is reduced; if required re-adjust.
Pull out the mains plug.

Loosen clamping nut (1.).

Set required mitre angle with the aid

of the scale (2.).
Tighten clamping nut (3.).

CS 60 WET