Environmental Protection - GRAPHITE 58G792 Manual Del Usuario

REPLACING THE CARBON BRUSHES
Worn (shorter than 5 mm), burnt or cracked motor carbon brushes should be immediately replaced.
Both carbon brushes should be always replaced at the same time.
● Loosen the covers of the carbon brushes (4) (fig. E).
●
Remove the worn carbon brushes.
●
Remove any carbon dust using compressed air of a lower pressure.
●
Insert new carbon brushes (brushes should easily slide into the brush holders) (
●
Fasten the covers of the carbon brushes (
After the carbon brushes are replaced, switch on the tool with any load for approximately 3 minutes
to make the carbon brushes fit the motor commutator. Carbon brushes should be replaced by a
qualified person using original spare parts only.
All types of faults and defects should be eliminated by an authorised service of the manufacturer.
RATED DATA
Parameter
Power supply voltage
Power supply frequency
Rated power
Idle speed range:
Chuck range
Torque control range
Maximum torque
Protection class
Weight
Year of manufacturer
NOISE AND VIBRATION DATA
Acoustic pressure level: Lp
Acoustic power level: Lw
Vibration acceleration value: a
Do not dispose of electrically powered products with household wastes, they should be utilized in
proper plants. Obtain information on wastes utilization from your seller or local authorities. Used up
electric and electronic equipment contains substances active in natural environment. Unrecycled
equipment constitutes a potential risk for environment and human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa
Topex) informs, that all copyrights to this instruction (hereinafter Instruction), including, but not limited to, text, photographies, schemes,
drawings and layout of the instruction, belong to Grupa Topex exclusively and are protected by laws accordingly to Copyright and Related
Rights Act of 4 February 2004 (ustawa o prawie autorskim i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments).
Copying, processing, publishing, modifications for commercial purposes of the entire Instruction or its parts without written permission of
Grupa Topex are strictly forbidden and may cause civil and legal liability.
4).
SPECIFICATIONS
Electric drill driver
speed I
speed II
= 85 dB(A) K = 3 dB(A)
A
= 96 dB(A) K = 3 dB(A)
A
= 3.25 m/s 2 K = 1,5 m/s
h

ENVIRONMENTAL PROTECTION

Value
230 V AC
50 Hz
250 W
0-400 min
0-1450 min
0.8-10 mm
1-23 plus drilling
21.5 Nm
II
1.3 kg
2014
2
15
fig. F)
-1
-1