Operation And Use - Felisatti T770 Instrucciones Para El Uso

5.6 VERTICAL PLANE LIMIT STOP ADJUSTMENT
(0° - -45°) (fig.21)
- Lower the head of the machine and lock it with the
special pin.
- Place the turn-table on 0 and lock in position.
- Adjust the head on 45° and position square A, as in
fig.21.
- Regulate the 45° by means of screw B, after having
loosened the nut.
- Tighten the nut in order to be certain that the position
will remain unchanged.
BLADE WIDIA
CAUTION: modelsT 777 CE - T 778 CE are equipped with motor speed adjustment. The value given in the table shows
the position of speed selector according to the material to be machined.
6.2 CUTTING WITH THE BLADE AT 90° AND THE
TURN-TABLE ROTATED (fig.4 and fig.5)
- Unlock turn-table A by releasing the knobs A (fig. 10).
- Rotate the turn-table, using the handgrip, selecting the
desired angle by means of the graduated scale and
index B, then lock knobs A once more.
Note: there are prefixed cutting angles (0° ±15° ±22°30'
±30° ±45°) on which the turn-table can be easily locked
(except T770 and T771).
6.3 CUTTING WITH THE BLADE AT AN ANGLE
AND THE TURN-TABLE AT 0° (fig.6)
- Unlock the blade unit by loosening knob D (fig. 9).
- Rotate the blade unit selecting the desired angle by
means of graduated scale C (fig.10), locking knob D
once more.
6.4 USING THE MITRE SAW
CAUTION - Make sure that the lock button E (fig. 1) is
disengaged (protruding).
- Raise the upper surface to the maximum height.
- Start with the blade unit in the rest position (raised and
with safety pin inserted).
6
6.1 CUTTING SPEED
This mitre saw range cuts a wide variety of materials
with an extensive choice of different possible cuts. Given
this, the user must evaluate blade employment according
to the material, cutting speed and blade advance speed.
Some references to the above values are shown in the
table.
MATERIAL BLADE DIAM - N° TEETH
WOOD Ø 250 mm - Z 24
WOOD Ø 250 mm - Z 60
PVC Ø 250 mm - Z 60
ALUMINIUM Ø 250 mm - Z 60
FRAMES Ø 250 mm - Z 80
STEEL Ø 250 mm - Z 40
Ø 32 mm
- Firmly fix the material to be cut to the cutting surface.
CAUTION - When cutting aluminium or steel sections
the use of 6976000000 is indispensable.
- Start the machine and wait until the blade reaches max.
r.p.m.
- Press the blade unit release button.
- Gradually lower the blade unit and perform the cutting
operation.
CAUTION - Pressing on the handgrip stronger will not
reduce cutting time, but may cause reduced efficiency
due to motor overload.
6.5 BLADE START AND STOP
CAUTION - Check that the mobile protection casings
are correctly positioned when the blade is in its rest
position (raised).
The machine is equipped with a release push button C
(fig. 1) which starts and stops the blade.
It is possible to lock such switch into the "ON" position by
pressing the lock button E (fig. 1).
12

OPERATION AND USE

CODE
6554512098
0000512038
0000512038
0000512062
0000512085
0000512095
6537246464
G/MIN
4000
4000
4000
3000
4000
2000