General Description; Starter Mode; Charger Function - GYS GYSPACK 610 Manual Del Usuario

Congratulations for the selection of this product, which has been designed with great care. To
get the best use of it, please read carefully the following instructions. Keep this instruction
manual safe, you may want to read it again later.

GENERAL DESCRIPTION

This autonomous starter is intended for the starting of the vehicles equipped with a battery of
12 V with a liquid lead. GYSPACK functions thanks to a battery high performance. For an
appropriate use of the machine and a longer life cycle of its internal battery, it is essential to
connect the GYSPACK to the sector and to position the battery on OFF after each use. It is
recommended to leave it connected to the mains until further use
USE IN A STARTER MODE
1- Test the battery
Test the battery before each use: press on the button test
Green indicator: The battery is charged. Possible starting.
Orange indicator: It is strongly advised to reload before use.
Red indicator: obligation to reload. Warning: never use the
machine when the red indicator lights on.
2- Starting of a vehicle
1 - Leave the battery switch on OFF.
2 - Put the red grip at +, and the black grip at -.
When you hear a signal sound, you made an inversion of polarity.
!
In this case, disconnect and connect again the grips by respecting the polarity.
3 - Put the battery switch in ON position.
4 – Start on the vehicle.
5 – Put the battery switch on OFF, then disconnect the GYSPACK.
In general, a starting requires 400 to 500 A.
In case of several attempts, wait for a while before starting again.
A vehicle which does not start, can have a problem other than a battery discharge:
!
alternator, plug preheating,...
USE IN A CHARGER MODE (FOR INTERNAL BATTERY)
 Connect the charger to the power pack 230V 50/60Hz.
 The 3 lights red, orange and green show the state of the internal battery charge:
The red indicator lights when the connection to the battery is done and shows that the
charge is in process.
The orange indicator indicates a regulation phase, it remains less than 2 H of load.
The green indicator lights when the battery is charged.
It is recommended to leave the GYSPACK connected to the mains: the integrated charger will
prevent any damage to the internal battery.
Nb: If the devise stays more than 24 h in charge (red, orange light on), stop the charge. The
internal battery of your GYSPACK is damaged.
the result is posted:
4