Connecting The Power; Connecting To The Cmc; Configuring The Cmc; Connecting The Cmc To Your Network - Riverbed Steelhead CX Guía Rápida De Instalación

Installing the Central Management Console

3. Connecting the Power

If your model has a master power switch, make sure it is in the off position (on the rear panel).

Plug the power cord or cords into the CMC and an AC outlet.

If your model has a master power switch, press in the master power switch (ON).

Press in the system power switch on the front of the CMC.

Caution: In all European electrical environments, you must ground the Green/Yellow tab on the power cord. If you do
not ground the Green/Yellow tab, it can cause electrical shock.

4. Connecting to the CMC

Plug the serial cable into the Console port and a terminal.

Make sure the Console port settings are: 9600, 8 data bits, no parity, 1 stop bit, no flow control.

Start your terminal emulation program (for example, HyperTerminal or Tera Term Pro).

At the login prompt, type admin. The default password is password.


5. Configuring the CMC

The configuration wizard automatically starts when you log into the command-line interface for the

first time.
Follow the prompts to configure network and in-path interface settings for the CMC.

Confirm your settings; then type exit to log out of the system.


6. Connecting the CMC to Your Network

Make sure you use the correct cables to connect to your network:

– Straight-through cables: Primary and LAN ports to LAN switch.
112
Installing the CMC
Getting Started Guide