Connecting To The Mobile Controller; Configuring The Mobile Controller - Riverbed Steelhead CX Guía Rápida De Instalación

Installing and Deploying Steelhead Mobile
Plug the power cord or cords into the Mobile Controller and an AC outlet.

If your model has a master power switch, press in the master power switch (ON).

Press in the system power switch on the front of the Mobile Controller.

CAUTION: In all European electrical environments, you must ground the Green/Yellow tab on the power cord. If you
do not ground the Green/Yellow tab, it can cause electrical shock.

5. Connecting to the Mobile Controller

Plug the serial cable into the Console port and a terminal.

Make sure the Console port settings are: 9600, 8 data bits, no parity, 1 stop bit, no flow control.

Start your terminal emulation program (for example, HyperTerminal or Tera Term Pro).

At the login prompt, type admin. The default password is password.


6. Configuring the Mobile Controller

The configuration wizard automatically starts when you log into the command-line interface for the

first time.
Follow the prompts to configure network and in-path interface settings for the Mobile Controller.

Confirm your settings; then type exit to log out of the system.

56
Installing and Deploying Steelhead Mobile
Getting Started Guide