Configuring The Interceptor Appliance - Riverbed Steelhead CX Guía Rápida De Instalación

Tabla de contenido
Installing the Interceptor Appliance
Make sure the Console port settings are: 9600, 8 data bits, no parity, 1 stop bit, no flow control.
Start your terminal emulation program (for example, HyperTerminal or Tera Term Pro).
At the login prompt, type admin. The default password is password.

5. Configuring the Interceptor Appliance

The configuration wizard automatically starts when you log into the command-line interface for the
first time.
Follow the configuration wizard prompts:
Step 1: Hostname? Interceptor
Step 2: Use DHCP? no
Step 3: Primary IP address? 172.8.1.1
Step 4: Netmask? 255.255.0.0
Step 5: Default gateway? 172.8.1.254
Step 6: Primary DNS server? 172.8.1.10
Step 7: Domain name? domain.com
Step 8: Admin password? xxxyyy
After you have performed the initial configuration of the Interceptor appliance you must configure
and enable the in-path IP address. For example, at the system prompt enter the following set of CLI
commands:
Interceptor > enable
Interceptor # configure terminal
Interceptor (config) # interface inpath0_0 ip address 10.0.0.10 /24
Interceptor (config) # ip in-path-gateway inpath0_0 10.0.0.1
Interceptor (config) # in-path interface inpath0_0 enable
Interceptor (config) # write memory
Interceptor (config) # service restart
Getting Started Guide
Installing the Interceptor Appliance
145
Tabla de contenido
loading

Tabla de contenido