Troubleshooting - IKEA TVÄTTAD Manual De Instrucciones

ENGLISH
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install
the inlet hose again.

Troubleshooting

Warning! Refer to Safety
chapters.
Introduction
The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the table). If the problem persists, contact
the Authorised Service Centre.
Warning! Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an alarm
code and the Start/Pause
• - The mains supply is unstable. Wait until the mains supply is stable.
• - No communication between electronic elements of the appliance. Switch it off and
switch on again. The programme was not finished properly or the appliance stopped too
early. If the alarm code appears again, contact the Authorised Service Centre.
• - The appliance does not fill with water properly. After the proper check, start the
appliance again by pressing Start/Pause
cycle . If the error persists the alarm code will appear again.
• - The appliance does not drain the water.
• - The appliance door is open or not closed correctly. Please check the door!
If the appliance is overloaded, remove some items from the drum and/or hold
the door shut while touching the Start/Pause
stops flashing (see the picture below).
button may flash continuously:
button the appliance tries to resume the
Warning! Make sure that the
temperature is higher than 0 °C
before you use the appliance
again.
The manufacturer is not
responsible for damages caused
by low temperatures.
button until the indicator
32