Dc Voltage Measurements - koban KMD-14 Instrucciones Operativas

1. Press the DATA HOLD button to "freeze" the reading on the
indicator. The indicator "HOLD" will be appear in the display.
2. Press the DATA HOLD button to return to normal operation.
MAX HOLD BUTTON
The max. Hold position is used to measure the maximum
The maximum measured
once again the button, will release the hold and allow a further
measurement.

DC VOLTAGE MEASUREMENTS

CAUTION: Do not measure DC voltages if a motor on the circuit is
being switched ON or OFF. Large voltage surges may occur that can
damage the meter.
1. Set the function switch to the V DC position ("mV" will appear in the
display).
2. Insert the black test lead banana plug into the negative (COM) jack
and the red test lead banana plug into the positive (V) jack.
3. Touch the test probe tips to the circuit under test. Be sure to observe
the correct polarity (red lead to positive, black lead to negative).
4.
Read the voltage in the display. The display will indicate the
proper decimal point and value. If the polarity is reversed, the
www.grupotemper.com
AUTORANGING MULTIMETER
is up dated continuously. Press
value
KMD-14
.
value
13