Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. Touch the black test probe tip to the negative side of the circuit. And
touch the red test probe tip to the positive side of the circuit.
8. Apply power to the circuit.
9. Read the current in the display. The display will indicate the
proper decimal point, value and symbol.
CLAMP–ON
MEASUREMENTS
1.
Set the function switch to the A DC/AC
2.
Insert the
clamp–on adaptor
negative (COM) jack and the red test lead banana plug into the
positive (V) jack.
3.
Press the MODE button until "AC/DC" appears in the display.
4.
Press the trigger to open jaw. Fully enclose one conductor to be measured.
5.
Read the AC/DC current in the display.
NOTE: The output analog signal Sensitivity of The AC/DC CLAMP–ON
ADAPTOR is 1mV/A
www.grupotemper.com
AUTORANGING MULTIMETER
ADAPTOR
black test lead banana plug into the
KMD-14
AC/DC
CURRENT
(clamp–on adaptor)
position
17
Tabla de contenido
