Sanding Surfaces; Rough Sanding; Fine Sanding - Worx WX652 WX652.1 Manual Del Usuario

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for dry sanding of
wood,plastic, metal and filler material as well
as painted surfaces.
Machines with electronic control are also
suitable for polishing. The sander is not to be
used for plastering.
1. CHANGING HOOK & LOOP
SANDPAPER (See A, B)
The sandpaper and sanding plate are provided
with a hook and loop attachment system to
allow quick and easy changing of the sanding
and polishing accessories. Firstly, remove any
dust or other objects from the hook and loop
on the sanding plate and sandpaper. As the
sandpaper has dust extraction holes you must
align these with the holes in the sanding plate,
otherwise the dust extraction will not function.
(See A)
To remove the sandpaper, lift one corner of
10
the paper and pull off from the sanding plate.
(See B)
2. DUST BAG (See C1, C2, D)
— ATTACHING THE DUST BAG (See C1)
Always operate your sander with the dust bag
fitted.
To attach, slide the bag onto the outlet piece
and take care that the latching lever engages.
CAUTION!
To prevent the possibility of sanding dust
or foreign body being thrown in to your face
or eyes, never attempt to use your sander
without the dust bag properly installed.
— EMPTY THE DUST BAG (See C1, C2, D)
For more efficient operation, empty the dust
bag every 5-10mins. This will permit the air to
flow through the bag better.
Method 1: To empty the dust bag, press the
latching lever in and pull off the bag from the
dust extraction port, and shake out dust. (See
C1, C2)
Method 2: To empty the bag, rotate the bag
Random orbital sander
to the unlock position. Remove the bag and
shake out dust. (See D)
3. OPERATING THE ON/OFF SWITCH (See E)
To start your sander, depress the protective
cover over the switch at the position marked "I" .
To stop your sander, depress the protective
cover at the position marked "0" .
4. HAND GRIP AREA (See F, G)
Your sander is designed to be held either
around the main housings, or by the top of the
main housing. When sanding for long periods
at a time, it is recommended you periodically
alternate between the two holding positions.

5. SANDING SURFACES

Place the machine with the complete Sand
paper on the surface to be worked. Ensure
uniform sanding pressure. Less sanding
pressure increases the sanding capacity and
protects the machine and the sanding tool.
The removal capacity and the sanding pattern
are determined mainly by the selection of
the Sand paper (grain size), the speed of the
sanding plate and the application pressure.

ROUGH SANDING

Attach a Sand paper with coarse grain.
Apply only light sanding pressure to achieve
increased material removal.

FINE SANDING

Attach a Sand paper with fine grain. With
moderate pressure, move the machine in a
circular pattern or alternately in lengthwise
and crosswise directions over the workpiece.
Do not tilt the machine to avoid sanding
through the work piece (e.g. when sanding
veneer). After finishing the work, switch off the
machine and lift it from the workpiece.
6. ORBITAL SANDING
Guide your sander parallel to the working
surface and move it in circles or in a cross
pattern. Do not tilt the tool in order to avoid
deep unwanted sanding marks. The amount of
material removed is determined by the speed
of the sanding disc and the grit size used. The
speed of the sanding disc diminishes relative
to the pressure applied to the tool. For faster
removal, do not increase pressure on the tool,
EN