Installing the foam
gasket
(for glass appliances)
Installation procedure
7351000
7351100
7353000
7353100
Installation procedure
7316000
7316100
7352010
CONNECTION TO THE POWER MAINS
Before inserting the appliance into the opening in the kitchen worktop, the supplied foam
gasket must be attached to the lower side of the glass.
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:
Remove the protective film from the gasket.
Attach the gasket to the lower side approximately A=2-3 mm from the edge. The gasket
must be attached along the entire length and should not overlap at the corners.
When installing the gasket, make sure that the glass does not come into contact with
any sharp objects.
Worktop must be absolutely horizontal;
Seal the cut surfaces with a suitable sealant to avoid swelling caused by moisture. The
sealant must be heat resistant;
Put the supplied springs in their places;
Feed the mains connection cable down through the cut-out;
Insert the appliance into the cut-out;
Press the appliance firmly towards the worktop from above.
The worktop must be completely level.
Protect the cut-out surfaces.
Screw on the support elements provided using the respective screws on the front and
rear end of the cooker hob (already configured with the relative holes and slots).
Connect the cooker hob to the mains electricity (consult the connection instructions).
Position the cooker hob in the cut-out.
Press it forcefully against the worktop.
The appliance may ONLY be connected by an authorized qualified technician.
Electric system protection should comply with all relevant regulations.
The connection clips can be accessed when the connection clip covers are opened /
removed.
Before connecting the appliance, make sure the voltage indicated on the rating plate is
consistent with the voltage in your home network. Connection voltage should be
checked by a qualified technician using a corresponding measuring device!
The rating plate with basic information is attached on the lower side of the appliance.
In order to make a fixed connection to the mains, insert an all-pole circuit breaker
between the appliance and the mains. This device shall have a contact separation in all
poles, providing full disconnection under overvoltage category III conditions.
The current conducting and isolated parts must be protected from any possibility of
direct contact.
16