Assemble And Install Adaptor - Haier QVM7167RNSS Instrucciones De Instalación

B4. ADAPTING BLOWER FOR
OUTSIDE VENTILATION
(continued)
5 Place the blower unit back into the opening.
CAUTION
Do not pull or stretch the blower
unit wiring. Make sure the wires are not pinched.
Replace blower motor screws removed in Step 2.
6
Slide cover plate into position on the back of the
unit. Replace blower plate and screws removed in
Step 1.
Blower Plate Screws
ASSEMBLE AND INSTALL
B5.
ADAPTOR
NOTE: On some models, the exhaust adaptor and
damper assembly may already be assembled to the oven.
1
Place the oven in its upright position, with the top of
the unit facing up.
and are pointing up.
Insert the tabs on each side of the damper into the
2
holes at the inside rear of the adaptor.
18
Installation Instructions
Blower Plate
Back of
Oven
Blower Motor Screws
Cover Plate
Damper
Exhaust
Adaptor
Blower Plate
Back of
Oven
Cover Plate
Attach the exhaust adaptor to the blower plate with
3
the two bronze metal screws provided.
Make sure that the damper pivots easily before
mounting oven.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
oven is installed.
B6. MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet. Keep it
tight throughout Steps 1–3. Do not pinch cord or lift
microwave oven by pulling cord.
Lift microwave, tilt it forward, and hook slots
1
at back bottom edge onto four lower tabs of
mounting plate.
Power Cord
Rotate front of microwave oven up against cabinet
2
bottom.
31-7000110 Rev. 1