Merrithew Health & Fitness SPX Reformer Manual Del Propietário página 13

Step 2. Removing Springs
1 . With 7/16" wrench, hold fixed cube nut in place.
. Remove spring from spring anchoring bar.
3
5 . Repeat steps 1 to 4 on remaining springs.
Spring Anchoring Bar
Fixed Cube Nut
2
spring anchoring bar, loosen nylon locknut. This may require
exerting a bit of torque.
NOTE:
provided with new springs.)
4
6
springs, if applicable.
Required Tool
. Using second 7/16" wrench on opposite side of
Discard used nylon locknuts. (New nylon locknuts are
. Pull spring out of the spring holder.
. Remove spring sleeves from old springs and slide onto new
TWO OPEN-END WRENCHES
1/2" X 7/16" (13mm X 11mm)
13