Downloading Further Instructions - Balluff BTL7-S5D-M Serie Instrucciones Breves

BTL7-S5 _ _ D-M _ _ _ _ -TT 2/3-S32/KA _ _ /FA _ _
Magnetostrictive Linear Position Sensor – Rod Style
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The BTL magnetostrictive linear position sensor, together
with a machine controller (e.g. PLC), comprises a position
measuring system. It is intended to be installed into a
machine or system and used in the industrial sector.
Flawless function in accordance with the specifications in
the technical data is ensured only when using original
Balluff accessories. Use of any other components will void
the warranty.
Opening the BTL or non-approved use are not permitted
and will result in the loss of warranty and liability claims
against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the BTL will not result
in hazards to persons or equipment.
If defects and unresolvable faults occur in the BTL, take it
out of service and secure against unauthorized use.

Downloading further instructions

A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
[email protected].
BTL7-TT-Cable BTL7-TT-S32
2) Unusable area
3) Not included in scope of delivery
1 english
Mounting surface
TT:
30-1 mm
Nominal length =
Measuring range
2)
Magnet
BTL-P-1028-15R
Thread size:
0.5 Ø 60
TT: M30x1.5
~80
25
Dimensions and function
The BTL contains the waveguide which is protected by an
outer stainless steel tube (rod). A magnet is moved along
the waveguide. This magnet is connected to the system
part whose position is to be determined.
The magnet defines the position to be measured on the
waveguide.
LED Operating state
Normal function
Green
Magnet is within the limits.
Programming mode
Flashing
Green BTL is in programming mode.
Error
Red
No magnet or magnet outside the limits.
Flashing Clock signal missing
Red No internal measurement is triggered.
1)
Not for BTL7-...FA_ _
Installation
NOTICE
Interference in function
Improper installation can compromise the function of the
BTL and result in increased wear.
► The mounting surface of the BTL must make full
contact with the supporting surface.
► The bore must be perfectly sealed (O-ring/flat seal).
Screw the BTL with mounting thread into the mounting
hole (max. torque 150 Nm for M30×1.5).
Damping zone 2)
60
3)
Permissible center offset
Magnet to rod:
±1,5 mm
Top view of the T_2-S32,
with dummy plug
File no.
E227256 1)
TT3
LED
Ø 100