Adjusting The Quantity Of Air-Blast And Injection Unit; Adjusting The Injection Unit En - Abicor Binzel BRS-LCi VW Instructivo De Servicio

6 Putting into operation

6.6 Adjusting the quantity of air-blast and injection unit

1
2
3
4
Fig. 8
For adjusting the quantity of injection and air-blast unit, the system must be provided with compressed air. In
order to assess the function, the solenoid valves Y3 and Y4 must be switched.
 Fig. 11 Connecting the pneumatic system on page EN-13
Danger of crushing
Limbs can be drawn in and crushed by moving parts (milling cutter, clamping unit).
• Do not reach between moving parts.
Damage to the eyes
Anti-spatter fluid and removed welding spatter may damage the eyes.
• Wear safety goggles.
• Adjust anti-spatter fluid only by switching the solenoid valve Y4.
• Adjust the blast air only by switching the solenoid valve Y3.
NOTE
• The injection results depend on the waiting times for air-cleaning and the working pressure.
• If the working pressure is too low, the waiting time for injection may increase.
• If the waiting time for air-cleaning is too long, the waiting time for injection may increase.
6.6.1 Adjusting the injection unit
1 If necessary, connect suction hose (11) to the anti-spatter fluid bottle.
2 Switch Y4.
3 Adjust the quantity of anti-spatter fluid by means of the adjusting screw (3).
4 Switch Y4.
EN - 10
1
12
11
9
10
Air-blast and injection unit 5/2 solenoid valve
5
Cleaning unit Reduce the spraying quantity
6
Adjusting screw Increase the spraying quantity
7
Valve block Supply line (compressed-air motor)
8
Adjusting the quantity of air-blast and injection unit
WARNING
WARNING
3
2
7
8
9
10 Vacuum generator
11 Suction hose (anti-spatter fluid)
12 Supply line (solenoid valve)
BRS-LCi VW
4
5
6
Non-return valve