Tabla de contenido
Idiomas disponibles
Idiomas disponibles
90538644 VP810
6/6/08
TWO POSITION SCREWDRIVER
To convert the tool to an angled screwdriver pull back on the release button shown in Fig.
4 and rotate the top portion of the tool as shown in Figures 5 and 6.
TWO POSITION SCREWDRIVER WARNINGS:
• To avoid being pinched, hold the screwdriver as shown in Figures 5 and 6 when changing
positions.
• Do not use screwdriver as a pry bar in either position.
• To avoid screwdriver being turned on accidentally, do not carry in your pocket.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement
parts.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
The use of any accessory not recommended for use with this tool could be
hazardous.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the nickel-
metal hydride battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Black & Decker. In some areas, it is illegal to place spent nickel-metal hydride batteries in
the trash or municipal solid waste stream and the RBRC program provides an
environmentally conscious alternative.
RBRC in cooperation with Black & Decker and other battery users, has established
programs in the United States and Canada to facilitate the collection of spent nickel-metal
hydride batteries. Help protect our environment and conserve natural resources by
returning the spent nickel-metal hydride battery to an authorized Black & Decker service
center or to your local retailer for recycling. You may also contact your local recycling
center for information on where to drop off the spent battery, or call 1-800-8-BATTERY.
Problem
• Battery will not charge.
• Tool will not drill.
• Screws stripping
• Screws not fully seated.
8:31 AM
Page 7
Troubleshooting
Possible Cause
• Charger not plugged into.
a working outlet.
• Surrounding air temperature
too hot or too cold.
• Torque adjustment collar in
wrong position
• Torque adjustment collar
setting too high.
• Torque adjustment collar
setting too low.
7
Possible Solution
• Plug charger into a
working outlet. Refer to
"Important Charging
Notes" for more details.
• Check current at
receptacle by plugging in
a lamp or other appliance.
• Check to see if
receptacle is connected to
a light switch which turns
power off when you turn
out the lights.
• Move charger and tool
to a surrounding air
temperature of above 40
degree F (4,5°C) or below
105 degree F (+40,5°C).
• Move collar position to
"2" drill mode.
• Move collar position to
a lower setting.
• Move collar position to
a higher setting.
Tabla de contenido
