Safety Instructions; Personal Safety; Important Notice - Volpi Olytech 455SP Manual De Empleo Y Mantenimiento

CHECKS AND ANOMALIES
COMPONENT
Clamps and connectors
Power cable
Tines
ANOMALIES (455SP-L-XL)
By pressing the
start button the
motor does not
turn on or turns
on slowly.
ANOMALIES (555SP-L-XL-655SP-L-XL-665SP-L-XL)
By pressing the All the LEDs of the power supply are off.
start button the
motor does not
turn on.
LEDs are regularly ON
LEDs are regularly ON
ALARM red light ON
ALARM red light ON (single impulse)
ALARM red light ON (multiple impulses)
9.

SAFETY INSTRUCTIONS

Codes 455SP-L-XL-555SP-L-XL-655SP-L-XL-665SP-L-XL

PERSONAL SAFETY

• For safety reasons, kids, young people below 16 years old and whoever is not familiar with the
"Operation and Maintenance Manual" cannot use the machine.
• Each time you need to clear or repair the machine, be sure that the electrical circuit is disconnected.
• Do not use the machine under rain.
• Do not use next to electrical cables at high tension.
• It may happen that some parts become hot during the usage. Don't touch.
• Do not switch on the machine while charging the battery.

IMPORTANT NOTICE

Operations not allowed:
• All modification to the machine are not allowed except it authorized by the manufacturer.
• Use of not original spare parts is not permitted. In case of utilization of not original parts all forms of
warranty will end.
•
During the operation of the machine it is advisable to use protective glasses.
• After using the machine, it is advisable to clean the engine area from dust and scraps and then put it
in a dry and clear zone, with batteries fully charged and disconnected.
VIBRATIONS AND NOISE
• Weighted root mean square acceleration value to which the hand/arm system is subjected is 7 m/ s
(maximum value).
• Equivalent continuous A - weighted sound pressure level=81 dB(A).
• Maximum value of the C - weighted instantaneous sound pressure Lpc<130 dB(C).
COMPANY WITH QUALITY SYSTEM
MANAGEMENT CERTIFIED BY ICIM
Tel. +39 0376 76009 Fax +39 0376 76408 www.volpioriginale.it
= ISO 9001 =
ACTION
Check the integrity and efficiency of
the contacts
Check that the cable is not twisted
Check the integrity and locking
CAUSE
Damaged clamps or connectors
Damaged cables
Damaged motor
Empty battery
Low battery
Other
CAUSE
Damaged clamps or connectors
Interrupted fuse
Damaged electronic power supply
Damaged cables
Damaged motor
Empty battery
Low battery
Anomaly
Davide e Luigi Volpi S.p.A.
Via San Rocco, 10 – 46040 Casalromano (MN) – Italia
FREQUENCY
Every day
Every day
Every day
SOLUTION
Replace
Replace
Replace
Replace or recharge
Recharge
Contact the service
point
SOLUTION
Replace
Replace
Replace
Replace
Replace
Replace or recharge
Recharge
Contact the service
point
2
43