Volpi Olytech 455SP Manual De Empleo Y Mantenimiento página 39

Use only 12V batteries. Do not use the machine with low battery. Outside temperature
between +1°C and +40°C.
Codes 555SP-L-XL Ref. fig. C.2
Before connecting the machine to the battery check the operating switch -N- in the OFF position.
Then proceed as follows:
• Link the connector positioned at the bottom of the pole -D- to the connector -E- positioned at
the end of the extension cable -S- and screw it.
• Insert the other connector -F- of the long cable S into the socket -G- on the electronic box -B-.
• Connect the electronic box -B- to the battery,12-24V, through the 2 nippers, the red one on the
positive (+) and the black one on the negative (-).
• The battery, not provided, must never be connected to the battery charger while used.
Now you can switch ON (-N) and start operating the machine. Switch OFF (-N) to stop the machine.
Maximum tension on the electronic circuit 29V. Over this vale the circuit could be damaged.
Minimum tension from the battery 8V.
Outside temperature between +1°C and +40°C.
Codes 655SP-L-XL Ref. fig. C.3
Before connecting the machine to the battery check the operating switch -N- in the OFF position.
Then proceed as follows:
• Link the connector positioned at the bottom of the pole -D- to the connector -E- positioned at
the end of the extension cable -S- and screw it.
• Insert the other connector -F- of the long cable S into the socket -G- on the electronic box -B-.
• The power supply B is connected to the knapsack battery H.
•
Switch on the battery with the J switch.
• The battery must never be connected to the charger while used. Now you can switch ON (-N)
and start operating the machine.
Now you can switch ON (-N) and start operating the machine. Switch OFF (-N) to stop the machine.
The electronic box of Olytech 655 must be connected ONLY to the original Volpi Lithium
battery.
Volpi Lithium battery characteristics: nominal voltage 43,2V – Capacity 11,6Ah.
Outside temperature between +1°C and +40°C.
Codes 665SP-L-XL Ref. fig. C.4
Before connecting the machine to the battery check the operating switch -N- in the OFF position.
Then proceed as follows:
• Link the connector positioned at the bottom of the pole -D- to the connector -E- positioned at
the end of the extension cable -S- and screw it.
• Insert the other connector -F- of the long cable S into the socket -G- on the electronic box -B-.
• Link the connector X of the electronic box B in the sead J of the battery H.
• Switch on the battery with the Z switch.
• The battery must never be connected to the charger while used. Now you can switch ON (-N)
and start operating the machine.
Now you can switch ON (-N) and start operating the machine. Switch OFF (-N) to stop the machine.
COMPANY WITH QUALITY SYSTEM
MANAGEMENT CERTIFIED BY ICIM
Tel. +39 0376 76009 Fax +39 0376 76408 www.volpioriginale.it
= ISO 9001 =
Davide e Luigi Volpi S.p.A.
Via San Rocco, 10 – 46040 Casalromano (MN) – Italia
39