Safety Information - Weller WTHA 1 Traducción Del Manual Original

Read these instructions and the safety
guidelines carefully before starting up the unit
and starting work.
Failure to observe the safety regulations results in a risk to
life and limb.
Keep these instructions in a place that is accessible to all
users. Please adhere to the operating instructions of the
connected devices.

Safety information

For safety reasons, children and youths
under the age of 16, as well as per-
sons who are not familiar with these
operating instructions, may not use the
device. Children shall not play with the
appliance.
This device is not intended for use by
persons (including children) with limited
physical, sensory or mental aptitude,
or by persons who lack knowledge or
experience in handling the device.
Keep other persons well away from your workplace.
The work area is out of bounds for children and unauthorised
persons. Never allow other persons to touch the soldering
tool or cable.
WARNING Electrical shock
Connecting the control unit incorrectly poses a risk of
injury due to electric shock and can damage the device.
Carefully read the attached safety information, the safety
•
information accompanying these operating instructions as
well as the operating instructions for your control unit before
putting the control unit into operation and observe the
safety precautions specified therein.
Only connect WELLER tools.
•
If the device is faulty, active electrical conductors may be
bare or the PE conductor may not be functional.
Repairs must always be referred to a Weller-trained
•
specialist.
If the electrical tool's power supply cord is damaged, this
•
must be replaced with a specially prefabricated power
supply cord available through the customer service
organisation.
Protect yourself against electric shocks. The handles on
soldering tools with an antistatic design are conductive.
Avoid touching earthed objects such as pipes, heaters,
•
cookers and refrigerators.
Do not use the soldering tool in a damp or wet environment.
•
Never work on voltage-carrying parts.
•
WARNING Risk of burns
Risk of burns from the soldering tool while the control
unit is operating. Tools may still be hot long after they
have been switched off.
Always place the soldering tool in the safety rest while not
•
in use. Make sure the safety holder is stable.
Only replace nozzles when cold
•
Risk of burning through liquid solder. Protect yourself
against solder splashes.
Wear appropriate protective clothing to protect yourself
•
against burns. Protect your eyes by wearing eye protectors.
When working with adhesives, special attention must be
•
paid to the warning information provided by the adhesive
manufacturer.
WARNING Fire hazard
Covering the soldering iron or the safety holder poses
a fire hazard. Always keep objects well away from the
soldering iron and safety holder.
Always keep objects well away from the soldering iron
•
and safety holder.
Keep all combustible objects, liquids or gases well away
•
from the hot soldering tool.
Do not direct hot air soldering tools at people or
•
inflammable objects.
GB
ENGLISH
17