Safety Information - koban KMD-13 Instrucciones Operativas

KMD-13
AUTORANGING MULTIMETER

SAFETY INFORMATION

The following safety information must be observed to insure
maximum personal safety during the operation at this meter:
Do not use the meter if the meter or test leads look
damaged, or if you suspect that the meter is not
operating properly.
Never ground
measurements. Do not touch exposed metal pipes,
outlets, fixtures, etc., which might be at ground potential.
Keep your body isolated from ground by using dry
clothing, rubber shoes, rubber mats, or any approved
insulating material.
Turn off power to the circuit under test before cutting,
unsoldering, or breaking the circuit. Small amounts of
current can be dangerous.
Use caution when working above 60V dc or 30V ac rms.
such voltages pose a shock hazard.
When using the probes, keep your fingers behind the
finger guards on the probes.
Measuring voltage which exceeds the limits of the
multimeter may damage the meter and expose the
operator to a shock hazard. Always recognize the meter
2
yourself when taking electrical
www.grupotemper.com